Measurement of wall cabinets
The cabinet of the wall cabinet can be either a wall or a mezzanine, which not only ensures the effective use of space, but also does not deform. However, the top and bottom must be horizontal and the two sides are vertical. If there is an error, the height difference between the left and right sides of the opening is required to be less than 5mm. The bottom wheel of the wall cabinet door can make up for the error through the debugging system.
Installation of the shelf
Home wall cabinets generally have drawers design. In order not to affect the use, pay attention to the position of the drawers: when making three sliding doors, avoid the intersection of two doors; when making two sliding doors, it should be placed on one door body side; when making a folding door, there should be a 17cm gap between the drawer and the side wall.
Installation of rails
When making the cabinet, it is necessary to reserve dimensions for the rails. The reserved dimensions for the upper and lower rails are 8cm for folding doors and 10cm for sliding doors.
Installation of closet doors
First fix the top rail, the front surface of the rail and the surface of the cabinet are on the same plane, and the upper and lower rails are placed in the reserved position; then install the two doors into the rail, measure the verticality of the door body with a level ruler or a ruler, and adjust the upper and lower rails Position and fix it; check again whether the door body is parallel to both sides, and adjust the door body by adjusting the bottom wheel to reach the level between the frame and both sides; finally, fix the anti-jump device and show the quality protection certificate.
