1. The cloakroom or installation space is small, and special methods should be used during installation.
①. If the cloakroom is very high, install it from the inside to the outside.
②, there is a top cabinet, first inside the cabinet and then outside, the lower cabinet and the upper cabinet are installed at the same time, and then the outer lower cabinet is installed.
③. Adopt vertical installation method, first inside and then outside, from left to right and from right to left, erect the side plate and connect the corresponding foot line first, connect the solid layer, the back foot line is fixed with corner code, and the back is nailed. After the board, people have to climb out from the top cabinet. If the space of the top cabinet is too small, the backboard behind the drawer can be sawed off, and then the backboard can be fixed with a corner code.
2. There are electrical sockets in the cabinet on site, you can open the hole with a measuring ruler, and the opening of the electric plug board is subject to the cabinet body against the wall. If necessary, install the power board on the back panel without opening any holes.
3. Solutions for cutting corners of top cabinets and beams:
Install the lower cabinet first, saw the top cabinet to the corresponding height, place it on the side panel of the lower cabinet, and see the sawing angle based on the spot ink.
4. The solution to the uneven connection between the two closing plates and the top line:
When the first closing board or top line is made, add a small board to the interface of the other board to expose 100-200mm. The purpose is to locate the board connected to it. The small board can be fixed with 502 glue or screws .
5. Analysis and solutions of problems when installing drawers:
(1) When installing the drawer, it is often encountered that the drawer board and the side board are not straight, and the gap is quite different. The reasons are:
①. The cabinet is inclined.
②. The marked line is not at right angles to the side plate.
③. The installation track is not parallel to the dotted line.
④. The distance between the fixed laminate and the dotted line is not accurate enough.
⑤. The three-in-one hole position of the drawer is not accurate enough.
⑥ The dotted lines on both sides are not at the same level.
Note: The dotted line refers to the line of the installation size marked with a pencil during installation.
(2) The reasons for the unsmooth movement of the drawer are:
① The empty space in the cabinet is not standard.
②. The drawer is not standard, including the size of the bottom plate, the size of the rear plate, and the deviation of the three-in-one hole position.
③ The quality of the track is not good, such as insufficient lubrication, metal burrs on the movable contact surface, deformation of movable parts, etc.
(3) The solutions to the above problems are as follows:
①. If the outside is loose and the inside is tight when the drawer is shaken, the situation usually occurs when the back plate is nailed without paying attention, causing the side plate to deform. You can use a hammer backing plate to knock it out on the inner surface of the side plate to restore the original shape.
②, if the rear panel or side panel is too large, it should be planed or sawed small.
③. Carefully check the quality of the track and replace it if there is any problem.
